Take the 2-minute tour ×
LEGO® Answers is a question and answer site for LEGO® and building block enthusiasts. It's 100% free, no registration required.

The LEGO logo that appears on the tops of brick studs has had several styles over the years. In the US, when Samsonite began manufacturing LEGO bricks, they apparently made some alterations to some of the molds they obtained from LEGO, resulting in occasional odd bricks that had both the older and newer style logos on the same brick:

Samsonite LEGO Brick

This brick shows the two main styles of logo, the earlier one with thick, rounded lettering and an open O, and the later style with thinner, italic lettering that is very similar to the style used today. There have been slight variations in the size and orientation of the logo, but these are the two main styles.

I have a few pieces, however, that have another distinct style:

Block LEGO Logo

This is also a thinner style, but is not italic, like the modern style. The pieces I have seen it on are white plates with the modern underside - not the old waffle type.

I want to know roughly when this logo was used - It would appear to be later than the old style logo, but concurrent with the modern logo. I am also wondering how long it was in use, and whether bricks with this style logo were produced in a specific place; i.e. whether they are Samsonite from the US or Canada, or distinct to one of the European manufacturing locations.

Additional Information

The pieces I have that display this logo are white 6x8 plates with Pat Pend on the underside in block caps. This style plate first appeared in sets in 1961, and I believe by 1976 most of the Pat Pend molds were either replaced or had the words obscured. That narrows the date range down somewhat for this particular piece.

If anyone has examples of other pieces with this style logo, especially if they are known to come from a certain set, that would be helpful in answering this question.

share|improve this question
5  
Note: I retagged this question with [history] instead of [identification], as you seemed to be asking about the history of the straight lettering than trying to identify something. Also, very interesting question -- can't wait see some answers! –  Peter Cassetta Mar 14 '12 at 14:55
    
@JoshuaDrake : bounty rules aren't very flexible, you can read them in full here. In short, if there's no answer, the bounty will not be awarded or refunded. –  Joubarc May 25 '12 at 13:23
add comment

1 Answer

NOTE: from 1949 to 1954 "LEGO" was printed INSIDE the brick.

LEGO appeared on the studs for the first time in the late 1954, then it was re-designed a lot during the years, becoming the stud we all know.

The not-italic stud of the photo was produced between 1960 and 1963. You can easily exclude 1963+ noticing that it's not the same exact plastic of the modern bricks (ABS was adopted in 1963).

Hope this helps. P.S. I'm a huge LEGO collector and I'll be glad to share my expertise here and learn from other passionate people.

share|improve this answer
1  
Thanks for the info. I'm not sure it quite coincides with this piece, however, because it's not a waffle-bottom plate, it's a circle-bottom, and the circle-bottom plates didn't come along until 1963 in Europe, and waffle-bottom plates were still the norm for this size plate in the US and Canada until the early 70s. So it's from 1963 or after. While the switch to ABS in Europe was in 1963, Samsonite still had some CA pieces in sets into the late 60s. Do you have any other pieces with this logo from a known set? –  62Bricks Aug 26 '12 at 16:32
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.