LEGO® Answers is a question and answer site for LEGO® and building block enthusiasts. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

We have multiple NXT Bricks. We can read sensor data and motor degrees from View. Some are running FW 1.31, others FW 1.28.

When we try a simple 5-step NXT program, the motors will not turn. We tries wait blocks after the move blocks. This only occurs on some of the bricks, and there is no correlation with the FW version.

share|improve this question

Did you use in program the same motors as you check via View? For example, maybe you view A and B motors, but in program uses C and D? If you have the following behaviour:

You check motors via View, then create a program and it works. After that you substitute NXT brick for another one, check the same motors via View but that same program doesn't work.

In that case I'd suggest to refresh firmware.

share|improve this answer
We made sure to use the correct motor ports when checking view and running the program. We will try refreshing the firmware. – Brian Feb 7 '14 at 17:05

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.