Take the 2-minute tour ×
LEGO® Answers is a question and answer site for LEGO® and building block enthusiasts. It's 100% free, no registration required.

I'm wondering whether the "bar holder" end of this element (http://www.bricklink.com/catalogItem.asp?P=11090) can be used as a stud. In other words, would it have enough clutch power to hold e.g. a 1x1 plate? And what about a 1x1 brick?

The reason for asking this question is that I'm looking for an element with a clip on one side and a stud on the other side. Sort of like this element (http://www.bricklink.com/catalogItem.asp?P=2555) but with a stud at the bottom. Any suggestions?

share|improve this question

1 Answer 1

One possible solution might be to use one of the new 1x1 round plates with open studs and a Bar with Clip

enter image description here

share|improve this answer
    
Thanks, that 1x1 plate element crossed my mind but I didn't see what part to connect it to. However, does this mean that the end of the Bar Holder with Clip can't be used as stud? –  Ailurus May 11 at 22:59
    
@Ailurus - Indeed - I think think the "Bar Holder" part of the description implies you can only insert a Bar into it :( –  Zhaph - Ben Duguid May 12 at 12:00
2  
I tried connecting the Bar Holder with Clip to a brick and a plate, and it is too large to be used as a stud. Obviously, you can stick a bar into it (like Zhaph said). –  rioforce May 13 at 15:13

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.