Take the 2-minute tour ×
LEGO® Answers is a question and answer site for LEGO® and building block enthusiasts. It's 100% free, no registration required.

I'm having trouble getting these lego technic pieces (on the image) apart and I dont want to use carpenter tools like pliers which may damage the bricks.

pieces to separate easily and safely

What tool can get the pieces separated without force that damages the lego or my fingers?

share|improve this question
always used muh teef in such conditions ;) –  Mints97 2 hours ago

3 Answers 3

up vote 9 down vote accepted

Push the Technic pin in a beam hole, then insert a rod (antenna or minifig tool handle) into the hole in the pin from the other side. The rod will prevent the "lips" of the pin from closing in, therefore preventing the pin from leaving the beam. Then you can pull on anything attached to the other end of the pin.

This example below shows the removal of a pin from a beam:

Example image with two beams

share|improve this answer
Heh, beat you by that much.. probably the time it took you to type a fuller explanation. :) –  gev 23 hours ago
Oh now look at you with your fancy pictures! :) –  gev 23 hours ago
Thank you for your fast tip! I found a solution and posted it below. –  Tim 23 hours ago

Stick the pin end into a Technic hole (like in the middle of those two red bits), then stick a light saber rod into the pin, and pull the red bit.


share|improve this answer
Thank you for your fast tip! I found a solution and posted it below. –  Tim 23 hours ago

I figured out a solution while waiting for answers. The tool I used for it was a universal T20 bit which most people have or can easily get access to. I took some documenting pictures of it which I would like to share here.

set up put the pin in the hole put the T20 in the hole pull them apart

share|improve this answer
Hard to argue with results, but I'm reluctant to apply metal tools when plastic will do. :) –  gev 23 hours ago
The results were good. I tried to take a photo of the inside but it was too blurry and dark. I don't have the laser beam but would for sure use it before the metal tool which is not round. SO my tip might help out those without the full lego brick set up. –  Tim 23 hours ago

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.