LEGO® Answers is a question and answer site for LEGO® and building block enthusiasts. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

I need to connect two bricks onto a plate such that the plate is facing up, and the two bricks are facing out from above it at an angle (say 30 degrees) but are connected firmly, at opposite ends with their studs facing out.

Ideally this would fit in around a 2 x 4 brick size, and not be too fragile.

enter image description here

The top image shows the two plates (assume 2x2) facing out at an angle from the 4 by 4 plate below.

The bottom image is the same from above. What I'd like to figure out is what to put in between. Assume that there will be stuff attached to the 2x2 plates, enough that the standard 2x1 hinge will probably just flop.

share|improve this question
A drawing would be nice – pcantin Dec 12 '11 at 12:04
Can the two angled pieces be connected to one another? That would strengthen the overall structure. – gnovice Dec 12 '11 at 18:46
The triangle is Isoceles, but not equilateral. The two angled pieces are not at 90 degrees to each other. – Danny Staple Dec 13 '11 at 10:14
up vote 11 down vote accepted

How firm does it need to be? Wouldn't something like this be enough?


If not, you can try to lock the parts into place with "cheese" slopes, but it's not as neat:

Slopes! And cheese!

share|improve this answer
That should work. I'll have to dig around to find the 2x2 tops for the hinge, I definitely have cheese slopes - if I can find grey or dark blue ones - I think the bottom assembly would be perfect. – Danny Staple Dec 12 '11 at 20:13

I'm not quite sure what you mean, but could you use hinges?

Like these?

enter image description here

share|improve this answer
Perhaps click hinges - but normal hinges are too floppy. I am going to put together a drawing later (no scanner handy) to explain better what I want to achieve. That looks like an old hinge - the middle finger is missing. – Danny Staple Dec 12 '11 at 17:50
@DannyStaple: It shouldn't be floppy once it's built, since it forms an equilateral triangle it should hold well. – Ambo100 Dec 12 '11 at 18:56
Not sure you can make a 60° angle with these, though. Seems too acute. – Joubarc Dec 14 '11 at 5:13

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.