I need to connect two bricks onto a plate such that the plate is facing up, and the two bricks are facing out from above it at an angle (say 30 degrees) but are connected firmly, at opposite ends with their studs facing out.
Ideally this would fit in around a 2 x 4 brick size, and not be too fragile.
The top image shows the two plates (assume 2x2) facing out at an angle from the 4 by 4 plate below.
The bottom image is the same from above. What I'd like to figure out is what to put in between. Assume that there will be stuff attached to the 2x2 plates, enough that the standard 2x1 hinge will probably just flop.