Take the 2-minute tour ×
LEGO® Answers is a question and answer site for LEGO® and building block enthusiasts. It's 100% free, no registration required.

It can be tricky to place small stickers accurately on small parts using adult-sized hands. The best technique I've found so far is to remove the sticker and stick it on the corner of the sticker sheet so that I can position the sticker above the part without my fingers getting in the way. Still, though, it can be difficult to center the sticker perfectly, and when the margin between the sticker and the edge of the part is small, tiny inaccuracies are easily noticeable.

What are the most effective techniques for applying stickers accurately?

share|improve this question

2 Answers 2

Another way is to stick a single side of the sticker to the piece, then give it a little tug without ripping it to make sure it's flat and has no wrinkles. Then apply the middle and other end.

share|improve this answer

For a rectangular sticker on a rectangular surface, I usually try to center it between two sides and align it along the top. This does cause the problem of centering the sticker up and down.

If I really care about the proper alignment, I use the end of a small knife blade to place the stickers properly. Just stick a corner of the sticker to the tip of the blade, align and stick. This has the added advantage that when you begin to place the sticker, the knife is still underneath and will allow you to remove it and try again if you miss.

share|improve this answer
    
I use the corner of the sticker sheet the same way you use the knife blade, but the knife is a better choice. I'm sure the rigidity of the knife helps with precision. –  Caleb Dec 26 '11 at 23:12

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.