I'm having trouble removing these LEGO Technic pins apart from their connectors and I don't want to use carpenter tools like pliers which may damage the bricks. What tool can get the pieces ...
Is there a way to set a flat plane at an angle to horizontal of less than 22.5 degrees, but more than 0?
I am building an airplane with a wing dihedral (the wings angle upwards from the fuselage), but I am using parts 44302 and 44301 interlocked as designed: Unfortunately, one click up is about 22.5 ...
My lego pieces, a stick 6m w/flange and a nose cone small 1x1 triangle, are stuck together. I've been trying to seperate them but they just won't. Any advice?
Black friction pin without slots connectors are common in older Technic sets. Note that these were quickly replaced by the current version with slots that is much easier to remove. vs Especially ...
Recently I made a LEGO race car with a driver who wore a helmet. Unfortunately, after the race, I tried to take off his helmet and his head came off inside the helmet. Any suggestions about getting it ...
We have a pulley and a bunch of rubber bands: We don't know that part numbers, but they all were part of a Mindstorms (RCX 2.0) set. My son was trying use the pulley and band to transfer power to ...
I've recently had some trouble removing a 1x4 hinge tile from the middle of a plate: Even when they are on the edge of the plate there isn't a lot of areas you can use to gain the traction to ...
This blogpost on Technic Bricks briefly explains a few 'brick paradoxes' or dead ends. This particular model seems impossible to disassemble by hand: How can I remove the axle without ...
How can I easily remove a jumper plate? I find a it very difficult to remove this kind of brick with a brick separator.
In my younger days I may have placed a few stickers on my bricks. Including some that covered multiple bricks. Now my daughter has the tendency to do the same thing :) How can I best remove the ...
Teeth and pliers tend to leave unsightly marks on the bricks. Fingernails don't work too well. What tool do you recommend to separate them?