Does anybody knows what is the technology the DUPLO Action Bricks are based on?It is not any RFID or NFC because I printed out the white one on normal white paper which turns lights on/off. The symbol on brick is not important - even white paper with symbol of printed rain drop turns the light on/off. I'm not able to make coloured ones - blue, red, green or yellow. Is the exact color shade so important? If so, then how to make own Action Bricks?
As seen in this question there is a sensor below the train. This is most likely to be a color sensor which is how it detects action brick.
Color sensor for some amount of time.
I was able to make green Lego tiles work, if the area I covered was 2x8 (in LEGO scale, not DUPLO) bumps. I put a standard Lego scale 4x8 brick under the Duplo track piece, and then built up the exposed area to the height of the center of the Duplo track, and then put 2 green Lego tiles (1x8) on top. This worked really well, but is not child safe.
Trans green (even with solid green underneath) does not register.
I ran two tests to verify this.
I cut the center tie out of a piece of straight Duplo track.
I used a standard Lego scale 4x12 centered under the piece of track.
This alone, did not cause the train to reverse (due to distance from sensor).
I then built up the area by putting a Lego 2x8 on top, taking the Lego bump top to the same height as the center tie would have been.
This was a tile less deep than my previous test.
This worked, the train did reverse.
This also worked with a 2x10, but only the length of 8 was needed to trigger the reverse.
I then tried using a Trans Green duplo track (without the center tie cut). I put the standard Lego scale 4x12 underneath and then built up the area on each side of the tie with Green Lego 2x4 bricks.
This did not work. The center tie, where the color was trans-green (on top of regular green), was an interruption.
None of my solutions are considered child safe. But if this is not a concern, I recommend the solution that does not alter the train track piece, and using Lego scale 1x8 tiles.
If choking is a concern, the solution where I cut out the center tie, and then use large standard Lego scale green bricks, is a bit safer. But even this solution, where the smallest brick is 2x10 (standard Lego scale), does not meet child safety requirements.
I bought some extra green Duplo smart tiles.