4

I would like to arrange 3 claws in a horizontal circle (parallel to the ground ), pointing outward from the circle with roughly equal radial distance (120 degrees) between them. Any ideas on how I can do that?

6

Your claws will fit in this Technic element:

enter image description here

https://www.bricklink.com/v2/catalog/catalogitem.page?P=10288

| improve this answer | |
  • Is there a simple way to convert from axle to claw? – Monte Gardner Apr 13 at 16:40
  • 3
    Claws have the usual 3.18mm bar at one end which fits the part mentioned in the answer. So you don't need to convert anything, unless your idea was to attach claws with a pointy end. – Alex Apr 13 at 16:59
  • @Alex The round peg fits in the cross-shaped hole? Is that a legal construction? – nick012000 Apr 14 at 5:21
  • 4
    Yes, 3.18mm end (peg) fits the inside of Technic connector. That is totally legal connection. Check 70001 set, for example, which uses both parts mentioned. – Alex Apr 14 at 5:50
  • Yes, bars fit nicely in axle holes, its also quite recently (like two years ago) that I learned this. – Michael Verschaeve Apr 14 at 10:33

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.