The SPIK3R does not move properly. When I remove the legs and depend on the wheels it works like it should: goes forward when I make it go forward, and turns when I make it go backward. I did not make this mistake and I am certain that it is built correctly. When I try to make it go forward with it's legs on it just wobbles around for a few seconds and then falls on it's rear end, then the legs pop off.

Also, the front and back legs are pointing straight to the ground because of this part and I'm thinking that I should replace it with this part to give it more flexibility.

Should I do that? Or is there something else wrong?

  • 1
    Could it be that the positions of the legs are not synchronised properly? Can you post a picture or a video of your built model or of the malfunctioning behaviour?
    – zovits
    Commented May 11, 2020 at 9:27
  • Whenever I get the chance, I will. Commented May 11, 2020 at 11:40
  • Did you get a chance? It's quite hard to answer this without seeing it in action.
    – Mast
    Commented Jun 23, 2020 at 5:25
  • @Mast No, not yet. For now just let this question sit here and do nothing until I do upload of picture or something. But it is not very likely anyway... Commented Jun 23, 2020 at 14:12


Browse other questions tagged or ask your own question.