4

Is there a way to make a more narrow v-shaped arch as in picture below? I looked at the arches section on Bricklink and they all look like they're too broad.

enter image description here

Improve this question
2
  • 2
    I wonder, if I could use the Slope, Curved 6 x 1 Inverted (part #42023). Perhaps I could place 2 of them vertically so they split at the top and then use other similar parts somehow.
    – Monte Gardner
    Commented May 18, 2020 at 13:44
  • This looks like it could be two arch pieces placed at right angles, and then the low camera angle/viewport gives it a more narrow visual effect.
    – agweber
    Commented Jun 3, 2020 at 18:21

1 Answer 1

Reset to default
4

Couple of Brick, Arch 1 x 3 x 3 pieces produce somewhat similar archway.

enter image description here

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.