2

How do I rotate a block 180 degrees after an item (like a car or train) passes a certain point in a track?

3
  • 1
    Do you have any prototype that you could share?
    – Alex
    May 21 at 9:16
  • 1
    Can you clarify if the block you would like to rotate is on the train or on the track? As many details as possible about your design would help too!
    – Ambo100
    May 21 at 10:59
  • I do not have a prototype. I was thinking a small switch to activate a rotation off the track after the vehicle passes the point. I noticed the power function set could be close to what I am looking for. I dont know of that helps.................................. Track-vehicle-switch activation-vehicle ........... .........................block turns .
    – Scooter
    May 21 at 17:13
2

Here's an idea for converting the movement of a moving train to rotational motion track side. This is shown in set 6991:

6991 action shot

The mechanism in this case is a tire hanging from a universal joint so that it engages the train without interfering too much:

build step 1

build step 2

This core idea could be mechanically adapted for other purposes, such as the 180 degree rotation that you are looking for.

1

If I understand the problem correctly, you have a track, on which something is moving in a straight line. Then you want to have another, stationary object to rotate when the moving something has passed a certain point on the track, right? Like a semaphore transitioning to another state after a train has passed a switchpoint?

If so, then the simplest solution would be to attach a piece of straight gear rack to the moving object and set up a gear by the tracks in a way so that the gear rack meshes with it as the object moves past. If the rack has exactly half the number of teeth as the gear, the gear will be rotated 180° upon their passing.

Possible combinations: 4566045: RACK W. BALL with 6 teeth: enter image description here

and 4141454: DOUBLE CONICAL WHEEL Z12 1M with 12 teeth: enter image description here

or: 374302: TOOTHED BAR M=1, Z=10 with 10 teeth: enter image description here

and 4141455: DOUBLE CONICAL WHEEL Z20 1M with 20 teeth: enter image description here

Due to the tight tolerances offered by these kind of teeth the alignment must be precisely calibrated and the passing speed should not be too high (especially if the rotational resistance or inertia is high) - in such cases knob or splat gears could provide better characteristics.

Or for very high speed applications the gear rack could be replaced with a long slope, which engages a single protruding piece and rotates it a bit by a horizontal axle while passing by. The resulting motion can then be amplified through adequate gearing to give 180° at the desired point and incorporate a ratchet to prevent returning after the slope has passed.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.