0

I have stared to build the above and I was half way through point of inserting the connectors to the hub. I have tried all the ports and looking at the schematic plan on on page 169 and have followed the instructions to the letter the diagram and I can only get the blue connections to work in the hub. I have been trying to figure it out for 4 days now

enter image description here

10
  • Apologies with bad explanation above I should of said the only connectors i have working is blue and green but cannot get the red and yellow connectors to show yellow and red as per the schematic plan above Jan 23 at 13:16
  • You mean you expect hub make LED's light up in these exact colors? Based on this diagram, colors are used here to help you align each motor with correct location in hub. Are you running a test within the mobile app and it fails?
    – Alex
    Jan 23 at 21:35
  • Hi Alex thanks for reaching out for me, I will take a couple of snap shots which may be easier than me explaining this issue if that’s ok with yourself Jan 24 at 9:53
  • Hi Alex I look on my controller app I have green and blue , ticked but I cannot seem to get yellow and red ticked as it shows two crosses Jan 24 at 14:54
  • Am I doing something fundamentally wrong ? Jan 25 at 10:50

0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.