I was thinking of building a model of the famous Castillo de San Marco located in Saint Augustine, Florida. A small bit of research shows that Legoland has a replica (flickr link) and that there are other castle MOCs with similar odd (non-90*) angles.

I saw one person build them with hinge-pieces (like this MOC of Fort George) but that doesn't feel authentic.

My question: how did they build those non-90-degree angled walls and retain the points?

3 Answers 3


Scale is the obvious answer. The Legoland model is huge, which means you're not seeing the brick-level quantisation as easily (quantisation is most obviously seen in mosaics but that works in 3D too).

Getting the same effect at smaller scales usually means a lot of SNOT and using sloped bricks. These days there is a huge range of slopes available, from 4 high, 1 deep to 1 high, 6 or 8 wide. If you flip those on their side (SNOT) that gives you a wide range of angles. But of course this can be very expensive as you end up using a lot of rare sloped parts. For micromodels this can be the only workable approach, and a carefully selected stack of cheese wedges can look great.

A simpler SNOT approach is to use tiles with hinges to minimise the discontinuities at the corners. Instead of a brick width (5mm) you have 1/3 of a brick height (8/3 mm = ~2.6mm), and it's often possible to move things so that there's no obvious discontinuity, just the tile end that's at 90° rather than the actual angle. If you're building a brick or stonework wall using a lot of 1x2 tiles with 1x1 tiles as the endworks can be very effective, especially if you mix the various shades of grey. Like this: http://www.flickr.com/photos/legoarts/5548508462/ Modifying that technique to have a backing plate, hinges, and extending the plates 1 stud past the edge of the plate to reduce the "height" offset works well.

Another approach is to give up on studs altogether and use Technic beams. That gives you rounded corners instead, but can be effective with larger models (but the colour palette is limited and it can be expensive). This allows you to easily build round structures and varying curves.

For smaller curves it's possible to bend Lego walls. If you search for lego circular walls there are a lot of images. The basic technique is to mix in more round elements as the curve gets sharper. I've also seen a Lego wave built this way out of transparent 1x2 plates.


Yeah you pretty much have the two choices you outlined... hinges or make it so big that the squareness of the bricks melts into nothingness at that resolution.

OR... build your structure over tiles and use single studs, like at the ends of the ends of the hypotenuse of a 3-4-5 triangle... but that will be seriously flimsy the higher you build the walls, unless you use hinges.


A straight forward wall of Lego bricks will have some pliability that can be used to a Master Builder's advantage. I did manage to find a YouTube video that sums it up nicely. https://www.youtube.com/watch?v=9U-n1NZYNpI

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.