3

We have multiple NXT Bricks. We can read sensor data and motor degrees from View. Some are running FW 1.31, others FW 1.28.

When we try a simple 5-step NXT program, the motors will not turn. We tries wait blocks after the move blocks. This only occurs on some of the bricks, and there is no correlation with the FW version.

Improve this question

1 Answer 1

Reset to default
1

Did you use in program the same motors as you check via View? For example, maybe you view A and B motors, but in program uses C and D? If you have the following behaviour:

You check motors via View, then create a program and it works. After that you substitute NXT brick for another one, check the same motors via View but that same program doesn't work.

In that case I'd suggest to refresh firmware.

Improve this answer
1
  • We made sure to use the correct motor ports when checking view and running the program. We will try refreshing the firmware.
    – Brian
    Feb 7, 2014 at 17:05

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.