I'm wondering whether the "bar holder" end of this element (http://www.bricklink.com/catalogItem.asp?P=11090) can be used as a stud. In other words, would it have enough clutch power to hold e.g. a 1x1 plate? And what about a 1x1 brick?

The reason for asking this question is that I'm looking for an element with a clip on one side and a stud on the other side. Sort of like this element (http://www.bricklink.com/catalogItem.asp?P=2555) but with a stud at the bottom. Any suggestions?

1 Answer 1


One possible solution might be to use one of the new 1x1 round plates with open studs and a Bar with Clip

enter image description here

  • Thanks, that 1x1 plate element crossed my mind but I didn't see what part to connect it to. However, does this mean that the end of the Bar Holder with Clip can't be used as stud?
    – Ailurus
    Commented May 11, 2014 at 22:59
  • @Ailurus - Indeed - I think think the "Bar Holder" part of the description implies you can only insert a Bar into it :( Commented May 12, 2014 at 12:00
  • 2
    I tried connecting the Bar Holder with Clip to a brick and a plate, and it is too large to be used as a stud. Obviously, you can stick a bar into it (like Zhaph said).
    – rioforce
    Commented May 13, 2014 at 15:13

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.