I have a dilemma where I am trying to push a 6.6L bar(4095)through 3 stacked pin connectors(62462) that have 1 long pin(6558) and 2 pins (4459) inserted. The bar only goes in a little bit and then it won't budge. I have a picture of it, if that would be helpful.

  • 2
    I second the motion for the picture idea.
    – pcantin
    Feb 17, 2016 at 3:30

1 Answer 1


The 2L pin normally fits a bar easily. But, there are older versions that have thicker sides (you can tell by the lip on the ends); you might check to see that yours are all the newer kind.

3L friction pins are all thicker, and do not allow a bar to pass through.


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.