# How to make a regular pentagon from technic bricks

For the purposes of this build, we need a pentagon (figure with 5 sides), that is regular (all sides have equal length), and it needs to be able to be mounted on a build (like a wreath) by a technic-friction-pin, (the little black ones).

This may be hard to achieve, with the given possible angles. The pentagonal shape must maintain its shape, no warping, etc. It must also be made of "properly fitting pieces."

• Do you allow for the use of non-current technic pieces? Mar 30, 2016 at 16:10
• Absolutely. Old pieces are always fun.
– user6907
Mar 30, 2016 at 16:27
• About what size and thickness are you looking for? Sep 16, 2016 at 17:29
• I'd really like to know this as well. I can think of several ways (will post one as answer) but I'd like something more elegant and compact and can't think of anything better Feb 1, 2018 at 9:21

## 4 Answers

Using the same length ratios as in the construction that Philo posted in his answer I created this:

It uses length 5, 6 and 7 thin liftarms (5 of each) and 30 half-pins I'm quite happy with it!

A solution, using a (quite precise) approximation: Granted, it's a bit bulky, but it could be reduced by half using 7.5 stud long stiffeners (eg. using Technic brick 1+ Technic brick 8 +plates)

Link to LDraw file: http://www.brickshelf.com/gallery/Philo/misc2/pentagon/pentagon.ldr

• I see the pentagon outer angle created by triangle with sides 15, 12 and 6 for a 108.21 degree which is indeed a good Approximation, but you could make it a third as small with a 5,4,2 triangle! Feb 1, 2018 at 16:44

I would suggest you use 10 of either one of these: 4273 Technic, Axle and Pin Connector Toggle Joint Toothed or 4273a Technic, Axle and Pin Connector Toggle Joint Toothed - Without Slots, together with 5 equal length axles and 5 pins. Creates a sturdy pentagon. Use the pin connector hole to attach the pentagon to other structures.

If you don't want axles, but bricks, you can mount connections onto the bricks to mount these 4273s the same way.

• It's impossible to create a pentagon with 10 Axle and Pin Connectors. The reason is simple, each angle of a pentagon must be of 108°. But pin connectors can only have the following angles: 90, 112.5, 135, 157.5 and 180°. So it's impossible to create a pentagon with these connectors.
– A.L
Sep 15, 2016 at 20:39
• You could argue that 112,5 is close enought to 108 degrees. The pentagram is indeed under a bit of stress though, axles are slightly bent Feb 13, 2018 at 11:16

A right triangle with sides 3 by 1 has as largest angle 71.5650512 and smallest 18.4349488 degrees. That is reasonably close enough to 72 and 18 degrees which can be used to create a pentacle. Lots of right angled connectors or beams you could use then...