I have two red 1×6 bricks that are slightly shorter than normal and also a bit deformed. For comparison, I here show them together with regular 1×6 bricks (the regular brick is the top one of each pair):

enter image description here enter image description here enter image description here

These bricks are shorter to the extent that considerable force is needed to connect them to regular bricks (note how much they are worn down). I suspect that they are rather old and made from some different material, however, I have many older bricks which connect considerably better to modern standard bricks.

Thus I wonder and ask: What could be the deal with those bricks? They are part of a huge connection containing second-hand bricks, so I cannot say much about their origin, except that they are from the last century.

  • Any idea on the source of the "shorter" ones? Just a guess on the "why" - they're knock-offs that completely violate/disregard Lego trademarks? That might explain the poor attention to detail on the length quality.
    – Sam
    Aug 17, 2017 at 1:06
  • @SammyB: See my edit.
    – Wrzlprmft
    Aug 17, 2017 at 7:39

2 Answers 2


For starters, having that as a production error is completely impossible, given the industrial precision of our beloved bricks. The LEGO group has been incredibly careful for decades about the tolerance of their bricks' dimensions:

  • You can read this WIRED article where the author compares old and new bricks' dimensions (TL;DR: they have been making really precise bricks for decades).
  • Their current standard for tolerance was 10 micrometers in 2009 - see page 20 of official LEGO documentation.

I think we can discard that option.

As @SlicksterTheBrickster said in his answer, the shorter bricks seem warped. The most plausible explanation is that extreme heat made the ABS plastic bend and get a little thicker on the walls or a little taller (floor to studs distance). ABS is a thermoplastic polymer (as opposed to a thermosetting one), meaning that it cannot withstand intense heat and it will melt. As an example, it's normal to wash and disinfect bricks with water at 40°C, but if you increase that to maybe 60°C or 70°C the plastic will start getting "plastic" (i.e. moldable). ABS is an amorphous material, meaning that it doesn't have a proper melting point and it transitions slowly (like glass). I would say that you can get the effect that you show by building a model and leaving it e.g. in a closed car under very hot sun with some pressure on the sides or strong torsion, or maybe close to a stove. The bricks will slightly bend and/or deform after the episode.

If you are curious, get a caliper and measure both bricks' height and width at several points all along their length, and do the same with the walls' width. I'm almost certain that the shorter one will have a significant variation in those values. If your question is "But where did that material go?", it went into slightly swelling the walls.


My thinking is that since the older and shorter brick looks a little warped, perhaps it was exposed to heat which caused the plastic to melt a little. I can't say this would be a production error as the pieces are injection molded and imperfections are kept down to a fraction of a millimeter.

  • Thank you for your answer. Can you elaborate why melting would shorten the brick? Also, did you really want to state “I can't say this would be a production error” instead of “I can say this would not be a production error”?
    – Wrzlprmft
    Jul 15, 2017 at 7:37

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.