2

Given the RC set of 5282 and 6272c01 below:

5282 6272c01

Is there a solution to use the two paddles that command the auxiliary output of the receiver for different functions?

For reference, see this at 1:45.

I'm trying to light two different 8870 led lights, one with the left paddle, the other with the right paddle.

enter image description here

  • Since the lights turn on for both directions, you would need a way to only pass current to them if the current is running in one direction. I'm not sure if there is a way to do that. – Alexander O'Mara Mar 18 '18 at 22:47
  • I hoped there are two circuits there, one for each paddle, but the new cables weren't wired to support that. – mike Mar 19 '18 at 11:55
3

With only using existing non-modified LEGO parts a mechanical solution with a servo motor, two polarization switches and cluch gears is thinkable, but this is all really cumbersome...

It's a bit ironic really, there's a bit of (trivial) circuitry in the 2x2 black brick before the wires of the LED lights split that causes the LEDs to work no-matter the polarization, because LEDs by their nature only work when the correct polarization is applied...

One solution would be to modify the circuitry in the 2x2 plate.

Schematics are here: http://www.philohome.com/pf/pflights.htm

What basically needs to happen is that the diode bridge is removed and the C1 wire is soldered through to the + side of the leds (to the resistors) and the C2 wire to - side ...

Same for the other pair of leds but switching C1 and C2...

  • Do you mean that 6272c01 does output differently depending on the pressed paddle? – mike Mar 19 '18 at 16:28
  • 1
    Yes, I believe that is the case. Don't have one to test myself but you could test yourself by attaching a motor. I believe the motor will turn in different directions when pressing the different paddles. – Michael Verschaeve Mar 19 '18 at 20:26
  • 1
    Indeed, the motor turns as you expect. – mike Mar 20 '18 at 18:04
  • I think it would be fun to modify a pf LED set so the diode bridge is short-circuited and switch the cables of one of the LEDs. Only one of the pair of LEDs would light up depending on which paddle is pressed... – Michael Verschaeve Mar 21 '18 at 8:40
  • Would be fun if I had any knowledge on the field, but I haven't. I understand the technical reason, though. – mike Mar 21 '18 at 9:36

Your Answer

By clicking "Post Your Answer", you acknowledge that you have read our updated terms of service, privacy policy and cookie policy, and that your continued use of the website is subject to these policies.

Not the answer you're looking for? Browse other questions tagged or ask your own question.