I have the following setup: Setup It consists out of

This is my program: ev3 program

It works fine if I provide a negative power to the unregulated motor (i.e. the LEDs light up for 5 seconds), however with a positive power, it flashes just shortly. This does not seem to depend on the orientation of the connectors between the conversion cables.

Also the motor test pane on the EV3 brick behaves similarly, the LEDs flash when pressing the button to move 'forward' and lights up continuously when pressing the 'reverse' button.

So I have an acceptable workaround, but I would like to know why this is.

1 Answer 1


The light turning off happens because of the Device Connection Manager in the EV3 firmware. The algorithm used to detect when a motor is connected relies on there being a load on pins 5 and 6 of the output ports to determine if the motor is a Large or Medium motor. The 8528 adapter cable only has wires on pins 1 and 2.

When you use a VM command (via a programming block or by using the on-brick app) to tell a motor to run, it forces the motor to run, but then the device connection manager immediately resets everything because it doesn't think that a motor is connected.

Also see How to use Power Functions with Mindstorms EV3?

The fact that setting a power of -100 keeps the power on continuously, though, is new to me. I'm at a bit of a loss to explain that observation.


I've done some digging and now I better understand what is going on.

Output port pin 2 is connected to pin 6 via a 100k resistor as seen in the schematic diagrams below.

electrical schematic depicting LEGO MINDSTORMS EV3 output port connector

electrical schematic depicting LEGO MINDSTORMS EV3 output port pin 6 electronic circuit

When the EV3 is instructed to run a motor in the forward direction pin 1 will have battery voltage and pin 2 will be at 0V. When running in reverse, however, pin 1 will be at 0V and pin 2 will be at battery voltage.

When using the converter cable, nothing is connected to pin 6 externally, so it will also be at battery voltage (pulled down slightly by R216 to +5V). This triggers an event in the device connection manager. Most of the time (but not 100% of the time) the EV3 will think that it has a motor attached because of this and so the LED will stay on.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.